Maker's Ark 3DTimelapse G-code
All toolsK-Snap ↗

K-SNAP TIMELAPSE G-CODE

Park. Pause.
Snap.

Choose the printer style, enter your K-Snap park position and copy the generated slicer G-code.

● Generated locally — nothing leaves this device
  1. 1Printer
  2. 2Park
  3. 3Copy

STEP 1

Choose the printer style.

Use the SparkX preset only for SparkX i7. For other machines, start with Generic and verify the result in your slicer.

STEP 2

Set the photo position.

Pick an X/Y point that the printer can reach without touching the model, clips or frame.

mm
mm
mm
Lifts the nozzle before the park move, then lowers it again.
sec
Give the printer and phone time to stop moving before the photo.
Advanced movement speeds
mm/s
mm/s
Before using this in a real print: move the toolhead to the chosen X/Y manually and confirm it is reachable and clear. This page cannot know your printer's physical limits.

STEP 3

Copy your G-code.

Paste this into your slicer's layer-change / timelapse G-code section.


      

      
Ready. Change any value above and the code updates automatically.